VETTE.TV™ Shark Fin Antenna Auto Car Radio Aerials

5D Shark fin antenna

By DA

Features and specifications:

5D shark fin antenna made from ABS plastic. It is coated in piano paint,Chrome Carbon and comes in 12 colors. Features a double adhesive for a strong hold.

Note:

The shark bottom hole measures 12.3cm/4.84inch x 5.7cm/2.24inch. Please make sure your antenna base is smaller than that to ensure fit. Otherwise,it can not install.

New design antenna cable for a stronger signal.

Fit these antenna base as below:

Shark size:

Length:21.3cm/8.39inch.

Width:8.2cm/3.23inch.

Height:6.8cm/2.68inch.

Bottom hole size:

Length:12.3cm/4.84inch.

Width:5.7cm/2.24inch.

Note:The shark bottom hole measures 12.3cm/4.84inch x 5.7cm/2.24inch.Please make sure your antenna base is smaller than that to ensure it,otherwise,it can not install.

Packing list:

Shark body 1 piece.

Copper Screw M5x10 1 piece.

Copper Nut M5 1 piece.

Double adhesive 1 piece.

Color:

Chrome

Carbon Black

Balck

Pearl Black

Matte Black

White

Pearl White

Silver

Gray

Dark Gray

Dark Red

Dark Blue

Display drawing

Easy to install

① Stick the double adhesive onto the bottom of the shark fin.

② Remove the original antenna.

③ Tighten screw and nut on the original antenna base.

④ Carefully align the shark fin and press down for 2 minutes to assure adhesion.

Frequently Asked Questions

Question 1:Is 5D shark same color with original car color?

Answer 1:5D shark fin color very close the original color,however, the car due to long-term exposure to outdoor, erosion by rain and snow,the color has changed, so impossible exactly the same as color,please understand.

Question 2:5D shark installed on the roof have a little gap, is appropriate?

Answer 2:5D shark bottom is curved,most of sedan models no have gap,the hatchback models and SUV models roof is flat,there may be have a little gap,it does not affect the use.You can use adhesive in to the gap.

Question 3:How about the radio signal effect after installation?

Answer 3:This antenna using purification copper fittings,through our tested,the signal close to the original car antenna.

Question 4:What should be note when installing?

Answer 4:Clean around antenna base,be sure not have water and dust,first connect the cable and base,test the radio,if it is ok,than installing,heating 3M adhesive with hair dryer before you install,it will become soft,viscosity will increase,only have one chance to paste,so be sure to alignment the positionpressing 3 minutes after pasted,keep dry in 2 days.